Terminals VMT5010
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
11
2 OPERATING INSTRUCTIONS
This device contains electrical voltages and extremely sensitive components. The
manufacturer, or a service partner authorised by the manufacturer, should be consulted if
you plan to make any modifications. For this type of work, the device must be switched off
at the mains and the power lead must be disconnected. Suitable measures for avoiding
electrostatic discharge towards parts of the components when touching the equipment
must be taken. If the device is opened by an unauthorised person, hazards for the user
might arise and any warranty claim will cease.
General instructions:
• All users must read this manual and have access to it at all times.
• Installation, commissioning and operation may only be carried out by trained and
qualified staff.
• The security instructions and the manual itself must be observed by all persons
who work with this device.
• At the location of use, the valid guidelines and regulations for accident prevention
must be observed.
• The manual contains the most important instructions on how to use this device in
a safe way.
• Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
Warning:
Any leads (e.g. power leads, interface cables) may only be connected if the device is
switched off in order to avoid damaging the device.
2.1 OPERATING LOCATION
The VMT control system is designed for use with support arm systems or on mobile base
equipment (commissioning trolleys, fork lift equipment, and similar). You have to take care
that the environmental conditions indicated in the technical specification are met. Using
the device in non-specified environments, for example on board ship or in areas that might
contain explosive gases, or in extreme heights, is prohibited.
Warning:
The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. The same applies if the device has previously
been exposed to extreme temperature variations.
To avoid overheating in operation: The device must never be exposed to direct radiation
by sunlight or any other light or heat source.
Pos: 12 /Datentechnik/ Betriebshinweis e/Schäden durch unsachge mäßen Gebrauch/Schäden d urch unsachgemäßen Ge brauch @ 0\mod_115882786 7958_681.doc @ 728 @
2.2 DAMAGE CAUSED BY IMPROPER USE
This device must immediately be shut down and protected from any accidental
commissioning if the operating system shows any obvious damage caused by, for example,
improper operating or storage conditions, or by improper use or handling.
Pos: 13 /Datentechnik/ Betriebshinweis e/Gewährleistung / Reparatur/Gewährleis tung / Reparatur @ 0\mod_ 1158828054427_681.doc @ 730 @
(35 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals